Snazzy-fx TRACER CITY Bedienungsanleitung PDF herunterladen

TRACER CITY MANUAL:

Hello, and congratulations on the purchase of a Snazzy FX device! What you have in front of you was

designed to provide the widest range of sounds possible, while still being easy enough to use that you

can easily start making sounds right away.. But first there are some things you should know.

1. WARNING: SNAZZY FX boxes can handle a wide range of inputs. Because of this, please watch

your volume, and never start with the box on FULL VOLUME unless your amplifier, audio

interface, or mixer is turned down. There are so many different ways to set the box up and some

modes are louder than others. Just be careful, as SNAZZY FX is not responsible for any damage

you may cause to your amplifier, stereo, audio interface, speakers, or your ears. These boxes

were designed to go anywhere you might want to take them but when you are first learning how

to use them, please exercise caution.

2. The TRACER CITY has both an input GAIN and an output VOLUME. This box is capable of input

distortion (when using line signals in GTR mode) and of output overdrive. Be very careful when

setting these levels. Make sure that if you are using LINE signals that you watch where you have

the LINE/GTR switch set. Also, Be very careful with the RESONANCE and CUTOFF controls. Full

resonance and little or zero cutoff can cause very large jumps in volume which can blow speakers

or damage equipment if you are not careful.

This wide range of resonance IS on purpose as many unique sounds can be achieved with resonance at

or near max. However, when exploring such sounds it is important to turn the volume down from normal

levels.

1 2 3 4 5 6 7

Seite 1

TRACER CITY MANUAL: Hello, and congratulations on the purchase of a Snazzy FX device! What you have in front of you was designed to provide the wi

Seite 2

Seite 3

1. GAIN 2. LINE/GTR SWITCH 3. VOLUME (OUPUT) 4. LFO DEPTH 5. OSC/LFO MODE SWITCH 6. TRI/SQR (LFO/OSC WAVEFORM SWITCH) 7. LFO SPEED 8. RAND DEPTH (ran

Seite 4

BASIC ADVICE ON USING THE TRACER CITY A: Start with your output volume at a low setting. B: ZERO out all DEPTH controls. C: Set input to LINE or

Seite 5

I: Begin brining in the depth of a modulator(LFO/OSC, RANDOM,CV1, CV2, OR ENVELOPE FOLLWER) J: Now adjust the controls of your modulator. K: Adjust c

Seite 6

distinct, which can be good for creating strange high resonance soundscapes. One useful experiment is to turn the output volume all the way down. Set

Seite 7

CV 1 and CV 2: These sections allow for external AUDIO or CV sources to control the cutoff of the FILTER. Without something plugged into CV 1 or CV 2

Keine Kommentare

Snazzy-fx TRACER CITY Bedienungsanleitung